SCSI RAID Installation

[Guest]

I am trying to install XP on a Poweredge 600sc and after pressing F6 and
installing my SCSI card drivers and pressing enter to begin the installation
it says hard drive not found, press F3 to quit. I have initialized the 4
drives in the SCSI setup utility and they are all online. What am I doing
wrong?

Thanks

 

[Guest]

The 4 drives are configured in a post start-up RAID configuration....What is
"initialized" ,do you mean a RAID set,this must be done in the RAID utility
and
will post at every start-up.Also,is BIOS set to SCSI/RAID,usually 3 areas to
enable in BIOS,chk owners manual....Otherwise,try 2,then add to the set after
xp is installed.