J
Jerry
To make a short story long, recently, I had some spyware installed on my pc
and the only way I could get it off was to restore the PC to a time before
the spyware was gotten Spybot nor Adaware neither one would remove it.
After restoring, one program <registered shareware> I had installed no
longer showed in All Programs nor could I make shortcuts to the .exe file.
It also no longer showed in the Add/Remove on the control panel, so I
reinstalled the program to the same place. Here is the issue: even with a
good SN, it would NOT allow me to register the program again so that I had
full use of the program.
I tried a couple of registry cleaning programs to fix the problem, to no
avail.
I ran regedit and did a find for the program and got a few hits. The
registry still showed the program as being installed. I held my breath and
deleted all the references I could find to the program, then rebooted and
reinstalled the program. It then allowed me to register the program and it
run as it should.
Here is my problem: I know I got very lucky this time as I know little to
nothing about editing the XP registry. Is there any good place to learn
about backing up, restoring and editing the registry?
and the only way I could get it off was to restore the PC to a time before
the spyware was gotten Spybot nor Adaware neither one would remove it.
After restoring, one program <registered shareware> I had installed no
longer showed in All Programs nor could I make shortcuts to the .exe file.
It also no longer showed in the Add/Remove on the control panel, so I
reinstalled the program to the same place. Here is the issue: even with a
good SN, it would NOT allow me to register the program again so that I had
full use of the program.
I tried a couple of registry cleaning programs to fix the problem, to no
avail.
I ran regedit and did a find for the program and got a few hits. The
registry still showed the program as being installed. I held my breath and
deleted all the references I could find to the program, then rebooted and
reinstalled the program. It then allowed me to register the program and it
run as it should.
Here is my problem: I know I got very lucky this time as I know little to
nothing about editing the XP registry. Is there any good place to learn
about backing up, restoring and editing the registry?