Install RC1 fail

[Guest]

I tried to upgrade from beta 2. First identified Nero so I deleted
completely with their clean tool. Then the installation went smooth but
final reboot just keeps repeating. Will not load into windows, just cycles
thru rebooting. I tired safe mode, repair and rollback. Nothing works.
Anybody else ?

 

[Guest]

--
Alfred Egan
My system does a similar failure at the first startup point
except that while safe mode also fails I can roll back to build 5384
My system is an Asus A8NVM-CSM with 1GB memory and a AMd 4200X2
This failure mode was seen in pre RC1 and RC1.

 

[Guest]

I tried to upgrade from beta 2. First identified Nero so I deleted
completely with their clean tool. Then the installation went smooth but
final reboot just keeps repeating. Will not load into windows, just cycles
thru rebooting. I tired safe mode, repair and rollback. Nothing works.
Anybody else ?

We see exactly the same problem. New PC, clean XP install, upgrade - seems
to progress fine, no errors. Never boots up after first reboot - continually
cycles. Also tried a clean install, same behaviour. This is meant to be our
Vista eval rig, so far the eval isn't going to be good.

Anyone got any ideas?

Max

 

[Guest]

Alfred Egan
Again, my system goes into a reboot loop just after the "starting for the
first time" message.
I have been looking at the log in the \panther\setupact files, it seems my
problem is a regristry based with the failure to clean up a few files just
before starting up.
Can anybody help me with this problem ?