Height in a table

[Stephen]

Hi,

I inserted a table inside another table. The width
automatically went to 100% of the outside table, which is
fine. But the height seems much higher than it hopefuly
needs to be.

I've pushed up the bottom border and a dotted line went up
but the bottom border didn't move. I went into both the
cell properties and table properties but both width and
height were grayed out, presumably, because they were
automatically inserted. I've tried to mess with them but
to no avail.

If anyone would like to look at the page it is at
http://stockmasters.net/reviews.htm.

The top table "News & Views" is the one that looks too
high to me. I'm still working on the table below it.

Thanks for any help.

Stephen

 

[Andrew Murray]

I found there are two blank links in the cell that has the "horserider" image.
Delete those lines and your table(s) will adjust (i.e. reduce the height).

See if the above helps and post back any further info.

thanks

 

[Stephen]

Hi,

Thanks so much for your help.

I'm new at this, so I wasn't sure what a "blank link" was
but I figured it out and then got them out. Now it is
fine.

Thanks again,

Stephen