FP2007 EWF Ram Registry

[Richard]

I may be doing this right but the EWFMGR output looks much different in
FP2007 then it did in SP1.
First, I take it that the EWF RAM REG component KM or Slobodin created "EWF
RAM Registry - Based on hotfix Q823025" can be removed from the database and
is no longer needed in FP2007. I did not use it for the below ordeal.


I have EWF set to RAM REG mode, volumns = 1, levels =1, size=256, HORM
Enable=UnChecked,
Vol 1 Settings...
EWF Enable = Unchecked, Disk# = 0, Partition = 1, Overlay = Ram Reg, Optimal
Performance


EWF Mgr shows this:

Shows all the infor for Volume 2 showing it's protected
then for Volume 1 shows HORM - Not Supported

Is this normal? It looks much different than the SP1 output.

Richard

 

[Richard]

Sorry, too early, I was leaving off the c: from EWFMGR. Argh... But The
RAM REG Componenet can be deleted correct?

 

[Sean Liming]

Yes. RAM-REG is now an option in EWF starting with FP2007.

http://www.seanliming.com/Docs/Articles/Feature Pack 2007 what is new.pdf

The old setup tricks of the past are no longer needed.


Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
Book Author - XP Embedded Advanced, XP Embedded Supplemental Toolkit