D
Dave Howey
I recently purchased a video card to capture TV analog.
When installed, I get a message that indicates that DMA
for the hard disk (WDC WD800BB-TS0AA0) in not enabled.
When I access the controller it shows the Primary IDE
Channel Properties for "0 Device" to be "PIO Only" and
for "1 Device" as "Does Not Apply". Upon several
attempts, including rebooting, they will not toggle to
Ultra DMA Mode 2-- which are the settings for the
Secondary IDE Channel Properties. The quality of video
is downgraded for TV and Capture. Anybody got a
suggestion?
When installed, I get a message that indicates that DMA
for the hard disk (WDC WD800BB-TS0AA0) in not enabled.
When I access the controller it shows the Primary IDE
Channel Properties for "0 Device" to be "PIO Only" and
for "1 Device" as "Does Not Apply". Upon several
attempts, including rebooting, they will not toggle to
Ultra DMA Mode 2-- which are the settings for the
Secondary IDE Channel Properties. The quality of video
is downgraded for TV and Capture. Anybody got a
suggestion?