Dialup Error 720, XP Pro

[Steve N.]

Hi -- I need help!

Windows XP Pro, all latest service packs and updates. I
get a 720 error when trying to connect over dial-up
networking. Have searched many hours online and tried
numerous KB et. al. suggestions like:

1) Resetting the protocol stack; (netsh ip reset...)
2) Various registry settings, etc.
3) Creating and recreating Dial-up connections.
4) Looking for WanMiniPort problems in Hardware setup.

Also, I don't have a restore point far enough back to fix
the problem, and I haven't tried the "repair" option on
installation (I'd rather not!)

I suspect the following error messages in the event log has
(on boot-up) are related:

IP could not open the registry key for adapter
TCPIP\Parameters\Adapters\NDISWANIP. Interfaces on this
adapter will not be initialized. (error 4191)

Unable to load C:\WINDOWS\System32\iprtrmgr.dll. (error
20103 -- I suspect this is because it couldn't find the reg
entries)

The Routing and Remote Access service terminated with
service-specific error 2 (0x2). (error 7024)

Any help would be ***greatly*** appreciated!!!!

Thanks,
Steve.

 

[Guest]

Hi Steve

If you find a solution please let me know. I have the same problem and tried all the "fixes" you mentioned to no avail

yoa

----- Steve N. wrote: ----

Hi -- I need help

Windows XP Pro, all latest service packs and updates.
get a 720 error when trying to connect over dial-u
networking. Have searched many hours online and trie
numerous KB et. al. suggestions like

1) Resetting the protocol stack; (netsh ip reset...
2) Various registry settings, etc
3) Creating and recreating Dial-up connections
4) Looking for WanMiniPort problems in Hardware setup

Also, I don't have a restore point far enough back to fi
the problem, and I haven't tried the "repair" option o
installation (I'd rather not!

I suspect the following error messages in the event log ha
(on boot-up) are related

IP could not open the registry key for adapte
TCPIP\Parameters\Adapters\NDISWANIP. Interfaces on thi
adapter will not be initialized. (error 4191

Unable to load C:\WINDOWS\System32\iprtrmgr.dll. (erro
20103 -- I suspect this is because it couldn't find the re
entries

The Routing and Remote Access service terminated wit
service-specific error 2 (0x2). (error 7024

Any help would be ***greatly*** appreciated!!!

Thanks
Steve