XPE hangs on splash screen after cloning

  • Thread starter Thread starter Porfus
  • Start date Start date
P

Porfus

Just FYI, the program I was using to clone the image is
Arconis True Image. Any suggestions are greatly
appreciated.
 
Did you include the System Cloning component in your configuration, and then
use Arcanus True Image to copy over your image to your target machine/s?

Do you still get the same behavior if you seal the image without first
adding your custom software?

Thanks,

Lynda

"This posting is provided "AS IS" with no warranties, and confers no rights"
 
Yes I used the system cloning tool. I set the reseal
phase to 0 so that I could add software and configure
network cards etc. When I was finished, I activated
fbreseal.exe, and then shut down. I am trying to clone
the image in it's state before it reboots after
fbreseal.exe so that when it first boots on the new
machine it will create a new SID. Problem is, it hangs
and will not boot like it does on my development machine.
The cloned drive is NTFS and is the exact same size as
the original partition. Should I only clone it to be the
same size as the actual image? The development partition
is 700MB, but the image is only 180MB. Could that be the
issue? Suggestions? Thank you!!
 
Back
Top