U.S. robotics modem

  • Thread starter Thread starter Roberto Cortiana
  • Start date Start date
R

Roberto Cortiana

I've a big problem with U.S. robotics modem.
I've installed correctly the modem to COM1, but when I reboot the machine,
the modem appears as 'not connected'.
Note that I reboot the computer with modem connected and switched ON.
What happens? thank-you very much.

Roby
 
Roberto,

Are you:
- working on XP Home/Pro? The you may want to post your question to
microsoft.public.windowsxp.general newsgroup. This NG deals with Windows XP
Embedded.

- struggling with XPe.. Then how did you install the modem?

KM
 
I work with XP embedded

ciao.

KM said:
Roberto,

Are you:
- working on XP Home/Pro? The you may want to post your question to
microsoft.public.windowsxp.general newsgroup. This NG deals with Windows XP
Embedded.

- struggling with XPe.. Then how did you install the modem?

KM
Click to expand...
 
I work with xp embedded.
I install the modem by "Phone and modem control panel" , Add and then I
install the modem.

Roby
 
Roberto,

Have you created the image? Do you have access to the image configuration
and XP Embedded Development Tools?
If not, you better off contacting your device manufacturer.

If you do, you may want to add the new hardware support in your image
configuration at first place and then build and redeploy the image to your
target device.

KM
 
Sorry, but I'm not able to find new hardware support in target designer.
Can you explain me how I can do wath you say?

thank-you very much.
Roby
 
Back
Top