Table Break Help

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I have a table made up of several sections. When one of the sections has a
long amount of text, the file is breaking to keep the section in tact. This
means I get one small section on one page, the next two small sectons on one
page and the long section on a third page. I would like the table to break as
it fills up a page, not as it is, which is keeping the section in tact on the
page.

How do I change the settings (and where do I go to do it) so that I get each
page to be full and the break is in the table section?

Thanks
 
Margaret:

It was close - but not quite there. I am still getting the break between
sections of the document. It is keeping each section in tact - leaving me
wide open blank spaces on the preceding page. Is it possible to get the page
break in the middle of the section? I tried ctrl+enter, but that did not work
either.

Thanks,
 
Are your rows set to allow page breaks? See Table Properties | Row tab.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.
 
Back
Top