Sidgen already pending warning message

  • Thread starter Thread starter Tony Yanez
  • Start date Start date
T

Tony Yanez

During the cloning phase (after FB Reseal) the system displays a "sidgen
already pending" message box. The process continues as usual after clicking
OK. What is causing this warning message?
 
Tony,

How did you set up reseal and cloning phases on your image?
Do you also manually call FBReseal?
 
Yes, in the System Cloning Tool the reseal phase cmi value is set to 0, then
I manually run the fbreseal utility after my image is finished and ready for
cloning.
 
Tony,

By any chance might it happen that you ran the FBReseal twice?
(if you are not sure, you can easy check that if you replace FBReseal.exe with something with more obvious UI or logging)
Also, check your FBALog for reseal messages.
 
Tony:

Keep in mind that fbreseal is deleted on your behalf after its run. It's
probably unlikely than you ran it twice since you would of had to restore
fbreseal manually.

HTH... Doug
 
Back
Top