Setting the Tab index in a worksheet?

  • Thread starter Thread starter Juan
  • Start date Start date
J

Juan

How can I program the sequence of cells the Tab or Enter focus goes t
in a Worksheet? So that I can skip all of the other stuff. Thank
again Excel Gods
 
Juan

To TAB to desired cells.......

1. Unlock the cells you want to TAB to then protect the worksheet.

If your unlocked cells are in a left to right, top to bottom series, the TAB
key will move you through them as long as Sheet Protection is enabled.

2. If not in this configuration.....you can do it with a Named Range and no
sheet protection.

Assuming your range of cells to be A1, B2, C3, F4, A2, F1 for example.

Select the Second cell(B2) you want in the range then CRTL + click your way
through the range in the order you wish, ending with the First cell(A1). Name
this range under Insert>Name>Define>OK.

Now click on NameBox(top left corner above row 1 and col A), select the range
name to highlight the range. With these cells selected, you can input data
and Tab or Enter your way through the range in the order you selected.

Note: there is a limit of about 25 - 30 cells to a range using this method due
to a 255 character limit in a named range. Longer sheet names will reduce the
number of cells considerably.

If more needed, you can enter them manually in thr "refers to" box.

From Debra Dalgleish.....
The limit is 255 characters in the Name definition. For example, I can
define a range of 46 non-contiguous cells, with the following string:

=$B$2,$D$2,$F$2,$H$2,$J$2,$B$4,$D$4,$F$4,$H$4,$J$4,$B$6,$D$6,$F$6,$H$6,
$J$6,$B$8,$D$8,$F$8,$H$8,$J$8,$B$10,$D$10,$F$10,$H$10,$J$10,$B$12,$D$12,
$F$12,$H$12,$J$12,$B$14,$D$14,$F$14,$H$14,$J$14,$B$16,$D$16,$F$16,$H$16,
$J$16,$B$18,$D$18,$F$18,$H$18,$J$18,$L$3
Click to expand...

There is a third method which requires VBA and a Worksheet_Change event.

''moves from C2 through E5 at entry
Private Sub Worksheet_Change(ByVal Target As Range)
Select Case Target.Address
Case "$C$2"
Range("C5").Select
Case "$C$5"
Range("E2").Select
Case "$E$2"
Range("E5").Select
End Select
End Sub

Gord Dibben Excel MVP
 
Thanks alot, I went with "Name Cell" solution. Now I was thinking abou
writing a macro that would select the name of the Tab sequence from th
"Name Cell" and have it run each time I open that worksheet. Then
could write one for all 6 of my worksheets. How would I write that ou
if my tab sequence is called "PurTAB" for the worksheet calle
"PURCHASE"?

I'm assuming that I would go to the VBA Editor and double-click on th
correct worksheet, but how would I tell it to run on the opening of th
worksheet? I used to remember but it's getting foggy, maybe becuas
it's past 3:AM here. Thanks for any help provided
 
Back
Top