Report / Subreport Question

  • Thread starter Thread starter nathan sanders
  • Start date Start date
N

nathan sanders

Hi,

I have a report which contains two subreports in the detail section.

I have the CanGrow and CanShrink properties for the subreports set to yes.

My problem is keeping the two subreports from overlapping each other.

How do I prevent them from doing this please?

Regards

Nathan
 
nathan sanders said:
Hi,

I have a report which contains two subreports in the detail section.

I have the CanGrow and CanShrink properties for the subreports set to yes.

My problem is keeping the two subreports from overlapping each other.

How do I prevent them from doing this please?
Click to expand...

The bottom of the upper one must be above the top of the lower one in design
view. Then the upper one will "push" the lower one down the page as it grows.
 
Rick,

That did the trick thanks. Is there any way of controlling the size of the
gap between the subreports on the printed page?

Nathan
 
nathan said:
Rick,

That did the trick thanks. Is there any way of controlling the size
of the gap between the subreports on the printed page?
Click to expand...

It will be exactly as big as the gap you create between them in design view.
If you temporarily make the borders of the subform controls visible you will
see what I mean.
 
Back
Top