Redirect Com port to USB?

  • Thread starter Thread starter RWL
  • Start date Start date
R

RWL

I have two devices that need to share the same Com port.
I have a USB to Com adapter, but the device isnt recognized when
plugged into the USB port. The software for the PDA will never be
updated to recognize USB ports, but if a Com port were redirected to
USB, it might work.

RWL

******* Remove NOSPAM to reply *******
 
I had a similar problem to this with PsiWin and a USB to COM adapter
which insisted on emulating COM5 - PsiWin does not recognise this port
by default. Thanks to advice from others, I found that rebooting the
system with the USB device attached allowed the PDA software to
recognise the non-standard COM port. This may work for you, too.

I have two devices that need to share the same Com port.
I have a USB to Com adapter, but the device isnt recognized when
plugged into the USB port. The software for the PDA will never be
updated to recognize USB ports, but if a Com port were redirected to
USB, it might work.

RWL

******* Remove NOSPAM to reply *******
Click to expand...


Please respond to the Newsgroup, so that others may benefit from the exchange.
Peter R. Fletcher
 
I had a similar problem to this with PsiWin and a USB to COM adapter
which insisted on emulating COM5 - PsiWin does not recognise this port
by default. Thanks to advice from others, I found that rebooting the
system with the USB device attached allowed the PDA software to
recognise the non-standard COM port. This may work for you, too.
Click to expand...

Thanks for the thought. It's been awhile since I played with it, but
I think I tried this without success. The software insists on looking
for a COM port. If I could convince WinXP that the USB was another
COM port, I might be able to get it to work.

RWL


******* Remove NOSPAM to reply *******
 
Back
Top