Problem with USB2 and Windows 98SE

  • Thread starter Thread starter brian
  • Start date Start date
B

brian

I recently installed a USB2 card on an old computer from Mesh with
Windows 98SE. Took several attempts for it to recognise the card but
after several reboots it did.

Seemed to work fine until I did a shutdown and the machine just hung.
No message given. Took the card out and everything worked fine.

Any help would be appreciated.
 
Thats usually a dead give-away of hardware incompatability,either try
putting it in a diffrent slot,and/or clear CMOS (remove battery,then put CMOS
jumper pin from 1-2 to 2-3 position for 1 minute or so,then back to 1-2,
replace battery,restart computer,"power off machine before".You should get
prompted to enter BIOS on restart,as the date.time will need correcting.
 
Back
Top