Print Server advice

  • Thread starter Thread starter Derek Davis
  • Start date Start date
D

Derek Davis

Can somebody assist me please. I have bought a Netgear PS110 print server
which will run on a 2k server box. I installed the supplied cd and then run
the
ipsetup, I have set the IP,mask & gateway but when I ok that I get a message
set fail check IP is in the same gateway/devise exists. The devise is on and
no fault lights exist a printer is connected although not configured through
windows. ( I figured that if the print server is not configured then windows
will not see the printer either).
I do not run DHCP all my connections are static.Can someone help me???

Regards

Del
 
I set one of these up 3 days ago, didn't get the error message you are
talking about.
Are you sure all IP details are correct. It almost sounds like the subnet
details are wrong.
 
what did the helpdesk say about the problem when you rang
them up.

Also, are you sure you have not given someone that ip
address, switch the print server off and see if you can
ping the ip which is causing the problems.
 
Thanks Wocka I found the problem. The default IP address in the book was
different from the actual unit. Once I established the connection I set the
browser and maaged to configure without any problems.
Thanks for the advise
Derek
 
Back
Top