Norton Ghost and SP2

  • Thread starter Thread starter CES
  • Start date Start date
C

CES

All,
I was wondering if anyone else has had a problem with Ghost PE that comes
with SystemWork 2004.
I just did a clean install of my system and updated it with SP2 right after
I installed the OS. I then did a Ghost of the drive and attempted to reload
the drive with the ghosted image (Lots of issues with BlueTooth)

After rebooting I got a memory error an then received a message that Windows
was unable to authenticate my windows key or some such statement that has to
do with the Windows Security Key. It wouldent let me log on and it then kept
rebooting the computer...I was wondering if anyone has dune the above and
has had the same problem, is this a known issue or is it just me????

I'm now on my third system install this time I'll add SP2 last.
CES
 
I think you cannot gost the computer which has windows xp sp2 which has
strong security featres
 
Unfortunately that's not the issue...I'm not using the MSFT Firewall and I'm
ghosting the image with a boot disk (as with booting into safe mode the
firewall service isn't loaded). The ghost work's fine and I'm also able to
check the integrity of the image with out receiving any errors. The problem
is when I load the ghost image onto the partition.

The issue has to be with SP2... I just setup my machine exactly as before
only I didn't update the system to SP2...Worked Fine!!!!

CES
 
Back
Top