My last EWF question for Slobodan

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I promise
Using RAM EWF Registry component I can now run ewfmgr c: and it sees the volume on the CF card. However, I can't enable protection. When I run ewfmgr c: -enable it displays

*** Enabling overla

Protected Volume Configuratio
Type RA
State DISABLE
Volume ID AC CD AC CD 00 7E 00 00 00 00 00 00 00 00 00 0
Device Name "\Device\Harddisk0\DP(1)0-0+1
Max Levels
Clump Size 51
Current Level

Memory used for data 0 byte
Memory used for mapping 0 byte

And I see the same report if I type ewfmgr c: again after trying to enable it, i.e. it is still disabled. Any ideas?
 
You must gracefully reboot your device.

Regards,
Slobodan

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Have an opinion on the effectiveness of Microsoft Embedded newsgroups? Tell
Microsoft!
https://www.windowsembeddedeval.com/community/newsgroups
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Colin Parker said:
I promise!
Using RAM EWF Registry component I can now run ewfmgr c: and it sees the
Click to expand...
volume on the CF card. However, I can't enable protection. When I run ewfmgr
c: -enable it displays:
*** Enabling overlay

Protected Volume Configuration
Type RAM
State DISABLED
Volume ID AC CD AC CD 00 7E 00 00 00 00 00 00 00 00 00 00
Device Name "\Device\Harddisk0\DP(1)0-0+1"
Max Levels 1
Clump Size 512
Current Level 1

Memory used for data 0 bytes
Memory used for mapping 0 bytes


And I see the same report if I type ewfmgr c: again after trying to enable
Click to expand...
it, i.e. it is still disabled. Any ideas?
 
Back
Top