Only way to clone your hard drive is to use Norton Ghost or Drive Image. If
you bought a Maxtor Dive or Seagate drive, then they have tools to do this
all for you.
After using these [Ghost or Drive Image] - boot up from floppy disk and
perform cloning in DOS mode and not in Windows - remove the old drive and
configure new drive in its place. The system amy boot up straight away from
the new drive: if not, you may need to perform a Repair Install:
1.Do Not BOOT into Windows XP on first boot after Motherboard or Hard Drive
change! If booting from CD is not an option, return to BIOS and make sure
booting from CD is the first boot option. Booting into Windows is only an
option when you do a direct replacement of the Motherboard.
2.If your computer does not support booting from the CD, check your OEM or
Motherboard makers web site for updated BIOS.
3.Perform a Repair Install by following the step by step below.
When you see the "Welcome To Setup" screen, you will see the options below
This portion of the Setup program prepares Microsoft
Windows XP to run on your computer:
To setup Windows XP now, press ENTER.
To repair a Windows XP installation using Recovery Console, press R.
To quit Setup without installing Windows XP, press F3.
Press Enter to start the Windows Setup.
Accept the License Agreement and Windows will search for existing Windows
installations.
Select the XP installation you want to repair from the list and press R to
start the repair.
Setup will copy the necessary files to the hard drive and reboot. Do not
press any key to boot from CD when the message appears. Setup will continue
as if it were doing a clean install, but your applications and settings will
remain intact.
Blaster worm warning: Do not immediately activate over the internet when
asked, enable the XP firewall before connecting to the internet. You can
activate after the firewall is enabled. Control Panel - Network Connections.
Right click the connection you use, Properties, and there is a check box on
the advanced page.
