Make mapped drive accessible at boot-up

  • Thread starter Thread starter Randy W. Sims
  • Start date Start date
R

Randy W. Sims

When Windows (XP) starts up and I log in, mapped network drives are not
accessible until they have been "browsed". I.E. if I open QuickBooks or
any other application and select a "Recently Used" file that exists on a
mapped network drive, it says the file is not accessible. However, if I
select "open" and select the mapped drive it will then connect.

Thanks,
Randy.
 
use net delete * command to delete all connection and the create a batch to map the drives with persistence: no. post back with the result.

Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
When Windows (XP) starts up and I log in, mapped network drives are not
accessible until they have been "browsed". I.E. if I open QuickBooks or
any other application and select a "Recently Used" file that exists on a
mapped network drive, it says the file is not accessible. However, if I
select "open" and select the mapped drive it will then connect.

Thanks,
Randy.
 
Back
Top