MACRO FOR PIVOT TABLE

[Guest]

Hi ,

I want a macro for creating pivot table.However I get an error after a
certain comand (indicated by------)

Following is the set of commands I have typed -

Sheets("Final Sheet").Select
ActiveWorkbook.PivotCaches.Add(SourceType:=xlDatabase, SourceData:= _
"'Final Sheet'!R1C1:R1567C43").CreatePivotTable
TableDestination:="", _
TableName:="PivotTable2", DefaultVersion:=xlPivotTableVersion10
ActiveSheet.PivotTableWizard TableDestination:=ActiveSheet.Cells(3, 1)
ActiveSheet.Cells(3, 1).Select
With ActiveSheet.PivotTables("PivotTable2").PivotFields("CODE")
.Orientation = xlRowField
.Position = 1
End With
ActiveSheet.PivotTables("PivotTable2").AddDataField
ActiveSheet.PivotTables( _
"PivotTable2").PivotFields("Type"), "Count of Type", xlCount
Range("A3").Select
ActiveSheet.PivotTables("PivotTable2").PivotFields("Count of Type"). _
Orientation = xlHidden
With ActiveSheet.PivotTables("PivotTable2").PivotFields("Type")
.Orientation = xlColumnField
.Position = 1
End With
ActiveSheet.PivotTables("PivotTable2").AddDataField
ActiveSheet.PivotTables
("PivotTable2").PivotFields("CTRY"), "Count of CTRY", xlCount

----------------------

Sheets("Sheet1").Select
Sheets("Sheet1").Name = "Pre Checks"
Range("A5").Select
Range(Selection, Selection.End(xlDown)).Select
Selection.Copy

Sheets("CHECKS").Select
Range("A2").Select
ActiveSheet.Paste

Can any one help me with this?

 

[pikapika13]

You're getting the error because Sheet1 isn't always the next sheet if
you're running this multiple times.
You probably need to add the first 3 lines below somewhere in the
beginning of your code to delete the "old" Pre Checks (Assuming you
don't need it anymore).
Then replace your

Sheets("Sheet1").Select
Sheets("Sheet1").Name = "Pre Checks"
with
ActiveSheet.Name = "Pre Checks"



Code:
On Error Resume Next
Sheets("Pre Checks").Delete
On Error GoTo 0


ActiveSheet.Name = "Pre Checks"

 

[Guest]

Thnx for the help.
However the sheet I am trying to rename is not an existing sheet. It gets
created from pivot table. It is always "SHEET1". I have been careful about
it. I tried to use the commands as given by you but I again land up with
the same error.