" lsass.exe - Entry point not Found " "The procedure entry point c

  • Thread starter Thread starter Tom
  • Start date Start date
T

Tom

I have just recently used Windows Update to Update to SERVICE PACK 2.
After the 40 minutes it took to downloand and update I was asked to
restart my computer.

When I resarted my computer I received the following error message. I
cannot boot into windows at all and when I click on "OK" to the error
box I just get a blank screen with my pointer with no desktop icons,
taskbar, or start button.

Here is the error I receive.

" lsass.exe - Entry point not Found " "The procedure entry point c
could not be located in the dynamic link library msvcrt.dll "

This only happened after I updated to Service Pack 2. I have done the
suggest fix on the Microsoft site that says to boot into the XP disk
and use the "r" utility to replace the file "Mscvrt.dll" and that did
not work either.

My computer doesn't work so I am checking this for a different one.
Thanks,

TOM
 
Thanks for the post. I have also tried that fix from Microsoft and it
still isnt' working. When I try to re-instate the msvcrt.dll by
using DOS commands and expanding that file it says that it was
successful. Then when I shutdown and restart I am still getting the
same error box on load up.

I cannot even log into "Safe Mode" because that gets the same error as
well.

I really cannot do too much besides running the XP disk and choosing
"r" repair.

Any other help would be appreicated. I am currently working with
Microsoft as well but they are really no help and are not even reading
my replies.

Tom
 
Back
Top