IR codes for use with Pronto remote control

  • Thread starter Thread starter LarryDJ
  • Start date Start date
L

LarryDJ

I'm integrating MCE into my home theater, controled by a
Pronto remote control. When I "learned" the codes from the
HP Remote Control into my Pronto, each button will work
just once, until another button is pressed. This is
undoubtedly due to what is known as a "toggle bit" in the
IR stream (I looked at the streams in hex, and saw the
toggle bits, I just don't know how to fix them). So, is
there available the raw Hex Codes for the commands that I
can then paste into my Pronto, or something else that has
solved this problem?
 
Thanks for the tip to TheGreen Button.

Actually, I found there that the irbus.sys driver in MCE
2004 is the culprit. It is dated 7/30 of this year. Older
versions of MCE have a driver that is dated late 2002 (I
think) that works perfectly. Unfortunately, when I updated
to MCE 2004, my previous drivers were lost. Now I'm trying
to find out how to get this "older" driver.
 
Someone sent me an their old version of the irbus.sys
driver. I installed it, and now my remote works perfectly.
 
Back
Top