How to configure the dual-channel display adapter settings?

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I'm trying to create an Windows XPE image (Evaluation Version for now) for
typical PC-like system with dual-channel display adapter (Matrox Millennium
P650). The system should start in the independent display mode which is not
the default mode (default is the single display mode). When I open the Matrox
component settings in the Target Designer I can modify the first channel
settings only. How can I set the independent mode and the settings (e.g.
resolution) for the second channel? Is it possible in the component
definition or in the configuration file? Or do I need to make changes
manually in the target system every time I deploy the new version?
 
Hi Leszek,

You must do that manually or from your application started during the FBA.

Regards,
Slobodan
 
I've been using Matrox Millenium G550 Dual Display for a while and in the end
the better way was not to use the components I created after a tidious
process. Instead I've got better results installing and configuring the
driver the "clasic" way after FBA completed its job on the target system.
Then you can reseal the image (optional) and use an application like Norton
Ghost to deploy the image on other systems.
I hope this helps.
 
Back
Top