Glbsstub error

  • Thread starter Thread starter Dean
  • Start date Start date
D

Dean

I am trying to install a program but when I do I get the following message

GLBSSTUB caused a general protection fault in
module ~GLC0006.tmp at 0003:2530.

I have searched for and tried the solutions that were recommended with no
success.
The solution mainly suggested is emptying the TEMP folder which I did with
no success.

Any Suggestions?

Dean
 
Have you searched for and deleted all GLBSSTUB files? Perhaps also run
Disk Cleanup in Acessories, System Tools
 
I've searched for GLBSSTUB files and found none, also ran Disk Cleanup. No
luck still cannot install.

Dean
 
Humm, are you also searching Hidden and System folders? C:\Windows\temp
may be hidden. If all else fails contact tech support for the program
that you are attempting to install.
 
Yes I have done all that. One question should I also delete all in the TEMP
folders under each user?

Dean
 
If you want to, it shouldn't hurt anything, I would be surprised if it
helps though. It's likely is a folder that is under your control during
the install rather than someone elses. Also don't skip over the vendor
tech support suggestion.
 
Back
Top