Fbreseal Question

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Somebody mentioned something regarding manually using FBreseal -keepall command. My question is: In order to have the FBreseal utility in my image I need to include the System Clonning tool; but once you add this component at the end of the FBA automatically my image is resealed ( FBreseal is executed). I need to do something else manually to my image previous applying reseal; so What do I need to setup in the target designer in order to use FBreseal Manually?

Thank

GLope
 
Hello,

Highlight the System Cloning Tool component. In the right pane click
advanced. Double click cmiResealPhase and set it's value to 0. Click OK,
then close. Investigate the other options that are available there as well.
You can specify to keep the computer name, user settings, and all kinds of
good stuff.

HTH,
--
Brad Combs
Imago Technologies, LLC

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Have an opinion on the effectiveness of Microsoft Embedded newsgroups? Tell
Microsoft!
https://www.windowsembeddedeval.com/community/newsgroups
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
GLopez said:
Somebody mentioned something regarding manually using FBreseal -keepall
Click to expand...
command. My question is: In order to have the FBreseal utility in my image I
need to include the System Clonning tool; but once you add this component at
the end of the FBA automatically my image is resealed ( FBreseal is
executed). I need to do something else manually to my image previous
applying reseal; so What do I need to setup in the target designer in order
to use FBreseal Manually?.
 
GLopez,

You may set cmiResealPhase extended property in the Advanced "System Cloning
Tool" Component Properties to "0" and it will not execute fbreseal
automatically. You will be able, however, to run fbreseal manually on your
target when you are done with your manual image tweaks.

--
KM,
BSquare Corporation
Somebody mentioned something regarding manually using FBreseal -keepall
Click to expand...
command. My question is: In order to have the FBreseal utility in my image I
need to include the System Clonning tool; but once you add this component at
the end of the FBA automatically my image is resealed ( FBreseal is
executed). I need to do something else manually to my image previous
applying reseal; so What do I need to setup in the target designer in order
to use FBreseal Manually?.
 
Thanks K

GLope

----- KM wrote: ----

GLopez

You may set cmiResealPhase extended property in the Advanced "System Clonin
Tool" Component Properties to "0" and it will not execute fbresea
automatically. You will be able, however, to run fbreseal manually on you
target when you are done with your manual image tweaks

-
KM
BSquare Corporatio
command. My question is: In order to have the FBreseal utility in my image
need to include the System Clonning tool; but once you add this component a
the end of the FBA automatically my image is resealed ( FBreseal i
executed). I need to do something else manually to my image previou
applying reseal; so What do I need to setup in the target designer in orde
to use FBreseal Manually?
 
Back
Top