EWF RAM Reg

  • Thread starter Thread starter Gianluca Facca
  • Start date Start date
G

Gianluca Facca

I cloned a disk containing an image EWF RAM Reg protected and the protection
was Enabled

On the cloned disk I execute the command "EWFMGR C: " and it return me the
error:
"Failed getting protectedvolume configuration with error 1."

After fbreseal the command "EWFMGR C:" works.

My questions are:
1)Have I to execute "Fbreseal" before to clone the disk?
2) does the protection (on the disk I clone) must be enabled or disabled ?
(I tryed to clone disk after Fbreseal command, (the protection was enabled)
and I had the same trouble )

Regards
Gianluca
 
Strange.

1. Are you using my component, or procedures to create your own component?
2. Make sure that there is no hidden EWF partition (created during FBA, or
left on your disk from long time ago)
3. Before calling fbreseal make sure that EWF is disabled.
4. Make sure that protected partition ARC path is same for both test and
cloned disk.
4. Call ewfmgr C: -enable, and immediately after fbreseal. (This will allow
fbreseal to write to registry, and next time after cloning ewf will be
activated).

Regards,
Slobodan

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Have an opinion on the effectiveness of Microsoft Embedded newsgroups? Tell
Microsoft!
https://www.windowsembeddedeval.com/community/newsgroups
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 
Back
Top