Error When Upgrading Motherboard and CPU "Windows Shut Down To Pre

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I have just replaced my Motherboard (MSI KM3M) and CPU (AMD XP300+). When I
try to Boot into window XP .. OR .. Run the Windows setup disk, I get the
error "A problem Has Been Detected and Windows has been shut down to Prevent
Damage to Your Computer. I Ran the Norton 2005 antivirus from the CD and no
viruses were detected. I turned off the virus check in the BIOS and this
allowed the XP setup to get to the point where I could select "R" to get a
command prompt. When it was doing it's Check Disk, it got to 78% and
restarted. I am going to put different memory on the motherboard in hopes
that that will help me, but I'm in the dark at this point. Has anyone has
this problem and what did you do? Thanks ... JD
 
John said:
I have just replaced my Motherboard (MSI KM3M) and CPU (AMD XP300+).
When I try to Boot into window XP .. OR .. Run the Windows setup
disk, I get the error "A problem Has Been Detected and Windows has
been shut down to Prevent Damage to Your Computer. I Ran the Norton
2005 antivirus from the CD and no viruses were detected. I turned off
the virus check in the BIOS and this allowed the XP setup to get to
the point where I could select "R" to get a command prompt. When it
was doing it's Check Disk, it got to 78% and restarted. I am going to
put different memory on the motherboard in hopes that that will help
me, but I'm in the dark at this point. Has anyone has this problem
and what did you do? Thanks ... JD
Click to expand...

You replaced the motherboard.. You likely need to perform a repair
installation.

http://support.microsoft.com/kb/315341
http://www.microsoft.com/windowsxp/expertzone/tips/dougknox/doug92.asp
http://www3.telus.net/dandemar/repaxp.htm
 
The XP setup won't let me get to the point to get to that option in the XP
setup. The same error message is displayed before I get to that screen. That
is why I went into the "R" command prompt to do a manual CHKDSK and after the
setup check disk gets to 78% it restarts..
 
John said:
I have just replaced my Motherboard (MSI KM3M) and CPU (AMD XP300+).
When I try to Boot into window XP .. OR .. Run the Windows setup
disk, I get the error "A problem Has Been Detected and Windows has
been shut down to Prevent Damage to Your Computer. I Ran the Norton
2005 antivirus from the CD and no viruses were detected. I turned
off the virus check in the BIOS and this allowed the XP setup to
get to the point where I could select "R" to get a command prompt.
When it was doing it's Check Disk, it got to 78% and restarted. I
am going to put different memory on the motherboard in hopes that
that will help me, but I'm in the dark at this point. Has anyone
has this problem and what did you do? Thanks ... JD
Click to expand...

Shenan said:
You replaced the motherboard.. You likely need to perform a repair
installation.

http://support.microsoft.com/kb/315341
http://www.microsoft.com/windowsxp/expertzone/tips/dougknox/doug92.asp
http://www3.telus.net/dandemar/repaxp.htm
Click to expand...

John said:
The XP setup won't let me get to the point to get to that option in
the XP setup. The same error message is displayed before I get to
that screen. That is why I went into the "R" command prompt to do a
manual CHKDSK and after the setup check disk gets to 78% it restarts..
Click to expand...

That sounds like a bum motherboard to me.. Possibly bad controller (HDD).
 
Back
Top