Epson R300 Flashing red light

  • Thread starter Thread starter BigBird
  • Start date Start date
B

BigBird

I have just replaced a couple of the cartridges. Two others are low (as
indicted by the windows status monitor and the LCD) but not empty. How do I
tell this silly light to stop blinking?
 
BigBird said:
I have just replaced a couple of the cartridges. Two others are low
(as indicted by the windows status monitor and the LCD) but not empty.
How do I tell this silly light to stop blinking?
Click to expand...

I don't think you can, its the [two others that are low]
 
Cover it with a piece of electric tape till you change the carts !!
Yer Welcome said:
BigBird said:
I have just replaced a couple of the cartridges. Two others are low
(as indicted by the windows status monitor and the LCD) but not empty.
How do I tell this silly light to stop blinking?
Click to expand...

I don't think you can, its the [two others that are low]
Click to expand...
 
NCHA said:
Yer Welcome said:
BigBird said:
I have just replaced a couple of the cartridges. Two others are low
(as indicted by the windows status monitor and the LCD) but not empty.
How do I tell this silly light to stop blinking?
Click to expand...

I don't think you can, its the [two others that are low]
Click to expand...
Click to expand...

Oh I do hope your wrong.
I have come to the conclusion it may be the new black cartridge which is
showing as 'unknown' all the way down the status monitor. Probably not
chipped correctly or faulty chip. The 2 Jettecs show up okay.

Cover it with a piece of electric tape till you change the carts !!
Click to expand...

Might just have to.
 
If one cartridge chip is faulty, you could have this problem, all
chips/cartridges will be shown as unknown, unknown date, unknown
manufacturer, etc. Take care, in this situation the chips don't record the
ink level, when they recover it will show more ink than they would contain.

--
Yianni
(e-mail address removed) (remove number nine to reply)

--
BigBird said:
Yer Welcome said:
I have just replaced a couple of the cartridges. Two others are low
(as indicted by the windows status monitor and the LCD) but not empty.
How do I tell this silly light to stop blinking?



I don't think you can, its the [two others that are low]
Click to expand...
Click to expand...

Oh I do hope your wrong.
I have come to the conclusion it may be the new black cartridge which is
showing as 'unknown' all the way down the status monitor. Probably not
chipped correctly or faulty chip. The 2 Jettecs show up okay.

Cover it with a piece of electric tape till you change the carts !!
Click to expand...

Might just have to.
Click to expand...
 
Back
Top