driver instalation

  • Thread starter Thread starter Jarek
  • Start date Start date
J

Jarek

Hi
when I build the image on target device. The run time
image is running, FBA finish succesfully. then I install
missing drivers (for example: audio), everything is fine,
sound working but after reboot is error, serious error:
system cannot start, the starting point is corrupt, error
in msconv.dll. What happend?
thanx for help
 
Hi,

First you should make component from your audio driver so TD and FBA PnP
will install it for you.

But in mean time can you tell us more about this serious error?

Is it blue screen?
What does it say. Error numbers, etc.
The more info you give us there will be better chance that we can help you.

Regards,
Slobodan

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Have an opinion on the effectiveness of Microsoft Embedded newsgroups? Tell
Microsoft!
https://www.windowsembeddedeval.com/community/newsgroups
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 
I guess in someway the dll is getting replaced or it's should be a bad
one.Can you check the dll entry point before the Reboot.*if you get
the error after the Reboot then you may check the dll status *.

As Slobodan says .. It would be better if you could check the same
after componentalising and making the FBA install the driver.I've had
bad times without installation thru FBA.

Kesavan
 
Back
Top