Discussion Web not working-HELP

  • Thread starter Thread starter friend
  • Start date Start date
F

friend

Whenever someone posts a message on the discussion web it adds all this code
before the message.
Any idea why?
 
Make sure your diss web is in a subweb.

Did you possibly publish it again; after you had some
threads?

Via live site; Go to your _private page with the articles
and remove them all.

Then go back to you hard drive site;
Open the table of contents page; where you should have the
inset tocproto. page. Make sure there are not unwanted
links. Open the tocproto. page and make sure there is
nothing else on that page and no unwanted links or spaces.
Close save and republish your web.

The Discussion Webs are very sensitive and they will mess
up every time you publish your web. So I was taught to put
them in subwebs and only edit them on the live site only;
once it's up and running (bit of a drag).
 
Lisa,

Kathleen is asking that you provide URL to your discussion web so that
someone can see why this is happening.

--

==============================================
Thomas A. Rowe (Microsoft MVP - FrontPage)
WEBMASTER Resources(tm)

FrontPage Resources, Forums, WebCircle,
MS KB Quick Links, etc.
==============================================
 
No this is not my question; the person 'friend' did post
her link; see above. But Thanks! I was just replying to
help out.
-----Original Message-----
Lisa,

Kathleen is asking that you provide URL to your discussion web so that
someone can see why this is happening.

--

==============================================
Thomas A. Rowe (Microsoft MVP - FrontPage)
WEBMASTER Resources(tm)

FrontPage Resources, Forums, WebCircle,
MS KB Quick Links, etc.
==============================================
To assist you in getting the best answers for FrontPage support see:
http://www.net-sites.com/sitebuilder/newsgroups.asp

there is no reply button? well I didn't see one?
try what I suggested above.
-----Original Message-----
www.worldwidewired.com
message board

"Kathleen Anderson [MVP - FP]"
Click to expand...
Click to expand...
wrote in message
Click to expand...


.
Click to expand...
 
Sorry.

--

==============================================
Thomas A. Rowe (Microsoft MVP - FrontPage)
WEBMASTER Resources(tm)

FrontPage Resources, Forums, WebCircle,
MS KB Quick Links, etc.
==============================================


Lisa said:
No this is not my question; the person 'friend' did post
her link; see above. But Thanks! I was just replying to
help out.
-----Original Message-----
Lisa,

Kathleen is asking that you provide URL to your discussion web so that
someone can see why this is happening.

--

==============================================
Thomas A. Rowe (Microsoft MVP - FrontPage)
WEBMASTER Resources(tm)

FrontPage Resources, Forums, WebCircle,
MS KB Quick Links, etc.
==============================================
To assist you in getting the best answers for FrontPage support see:
http://www.net-sites.com/sitebuilder/newsgroups.asp

there is no reply button? well I didn't see one?
try what I suggested above.

-----Original Message-----
www.worldwidewired.com
message board

"Kathleen Anderson [MVP - FP]"
Click to expand...
wrote in message
What code?

What's the web address?

--
~ Kathleen Anderson
Microsoft MVP - FrontPage
Spider Web Woman Designs
http://www.spiderwebwoman.com/resources/


Whenever someone posts a message on the discussion
web it adds all
this code before the message.
Any idea why?




.
Click to expand...


.
Click to expand...
Click to expand...
 
Back
Top