Clean install onto new serial ata harddrive

  • Thread starter Thread starter Billy
  • Start date Start date
B

Billy

I am going to do a clean install of XP to a new serial ata drive (as boot
drive}(non-raid). After installing drivers at F6, do i need to install any
thing else when XP is finished installing?
 
Before XP setup, you'll probably need to configure the SATA / RAID in BIOS.

Just make sure you set it as BASIC [non Mirrored: non striped].

Select the Correct Driver file from those available and put it onto floppy
disk: and away you go!
 
Back
Top