ATech Flash Pro 9 multicard reader

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I have installed and been working with the ATech Flash Pro 9 multicard
reader. It was working fine, however I believe since sp2 it (Windows XP
home) does not recognized the device properly. It is listed as an unknown
USB device. I have it installed internally. I did manage to get some
intermittent use, but now it just does not recognize it as the MFC. Anyone
with suggestions I could try?
Kevin
 
Did you ---
1) See if the manufacturer has a new driver release since SP2?
2) Reinstall the current driver to see if it will start working?

I have a "SanDisk" all-in-one, and had to reinstall the drivers after the
SP2 update.

--
Star Fleet Admiral Q @ your service!
"Google is your Friend!"
www.google.com

***********************************************
 
Thank Admiral for your repsonse, but this device uses no drivers ar a matter
od fact the company states not to install a driver under WinXP. Win XP is
suppose to recognize it automatically, I guess XP should have it's own driver
for this. None are available for ATech...
 
Hi Kevin,
I have two of these Atech's set up just like you do, internally. I have
three computers two which took SP2 fine and the one I'm using now choked
on the update. Format, re-install Sp-1 Pro.
I used a combo firewire & usb pci card to run an external f.wire drive
& the Atech. They had Via chipsets on the card. If your usb bus is Via
controlled, that may be the answer. You can check this out at:
'ViaArena' (http://tinyurl.com/4sg8b)
 
Yes Treeman you are correct,
MY USB bus is a VIA chipset. Thank you for your help and I will reload
sysytem. If all goes well i will close this string. Thank you all for your
help!
Kevin
 
my usb controller is intel and i am having the same problem. my pro 9
card reader dissapears and even when it works it's slower then usb 1.
it has worked beutifly before.
 
Back
Top