Before stop error


Eric Ferland

Before I get a stop error I get to the screen that looks
@ partitions and asks if I want make a new partition or
delete a partition or just run setup (I have tried all
and always come to a stop error.) But in the area which
shows you your partitions it says " 19093 MB at Disk 0 at
ID 0 on bus 0 on ATAPI. (Setup cannot access this disk.)
Do I have a bad hard drive?


Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question