windows xp repair feature wont finish!

D

Darren

Hi

I have windows xp pro, had a few small problems so I
decided to use the repair feature on the xp disk, all
looked as if it was going well until it got to 39% then it
rebooted. When setup resumed it was back to 34%, it then
continued on to 39% where it restarts. I just keeps doing
this over and over. Have tried using last know good to fix
this problem but it doesnt work! If anyone had any ideas
to fix this problem it would be greatly appreciated!!
 
P

Paul Riemerman

It sounds like it could be a piece of hardware that stops the install when
ever a setup scan runs into it. Try disconnecting all hardware (usb,
serial, parallel) except the mouse and monitor and retrying. If that doesn't
work, you could try also removing all cards except the video card (modem,
etc) and retrying setup.

Paul Riemerman
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top