Waste of time would by my feeling!
When a "modern" drive has enough errors, it runs out of reserved (by the
drive controller) spare storage, and starts showing errors to external
software and so forth.
I'd strongly suggest that you copy any important data, etc to another drive
as soon as possible. The errors usually spread, and make the drive
unreliable.
When the copying has been acomplished, see if you can obtain the mfrs
utilities for the drive. They may help you to make the salvage or replace
decision.
Given the current low cost of drives, I'd likely just replace it.
Since the drive is a USB drive, this is both a blessing and a curse.
Easier to replace, perhaps harder to dignose, due to the USB interface.
Today's price for a 1.5Tb drive are far less that the price I paid for my
first 40Meg drive.
"Bert Hyman" <(E-Mail Removed)> wrote in message
news:Xns9D8D65A2F82E8VeebleFetzer@207.46.248.16...
> The external (USB connected) hard drive I use for backups apparently has
> developed some bad spots. Formatting the drive starts producing System
> Event Log entries at about 12% into the format, with the decription being
> "The driver detected a controller error on \Device\Harddisk3\D."
>
> If I allow the format to continue, will it eventually plow its way through
> the bad area and mark those sectors as bad, or is this whole exercise a
> waste of time?
>
> --
> Bert Hyman St. Paul, MN (E-Mail Removed)