PC Review
Forums
Hardware
Support
Need Help Installing Card Reader
Forums
Hardware
Support
Need Help Installing Card Reader
![]() |
|
|
Thread Tools | Rate Thread |
|
|
#1 |
|
Junior Member
|
I have a internal 6-in-1 card readerbuild-in rsb and 1394 extention port. I don't know how to install it. It has three cables, one look like it hook to a usb slot but it not a usb cable the other have a cable with a split in, with lable on all four in, the labal are vcc,d+,d-gnd. one go to the usb, the other two go to the mother board. the reader is made by E-force and the name is super panel
card reader. Need help CB |
|
|
|
|
|
#2 |
|
Member
|
Have you tried their website for a PDF manual?
Nick
__________________
UK Software Development |
|
|
|
|
|
#3 | |
|
Captain Crunchie
![]() |
You'll need your motherboard manual to find out where the 'USB and Firewire header' is.
The normal pinout for USB is ... red = pin 1 = vcc White = pin 2 = d- (or data-) Green = pin 3 = d+ Black = pin 4 = grnd (ground) Pin 5, if there is one, is not used. I'm very surprised it does not come with any sort of 'fitting' instructions or manual. Quote:
That was taken from the manual of my card reader. The cabling is connected to the MB.
__________________
I'm not grouchy by nature, it takes constant effort. Inside every older person is a younger person wondering, "What the hell happened?" |
|
|
|
|
![]() |
|
| Thread Tools | |
| Rate This Thread | |
|
|

Main Page 



