NETCF 2.0 in Platform Builder 5.0

Hi guys,
Platform Builder 5.0 gets only netcf 1.0? I tried to build an image with the
wizard and the only netcf that I can select is 1.0
It's posible to use netcf 2.0?

Thanks,
Catalin

PB 5.0 came out before CF 2.0, so yes, by default it only has CF 1.0. If
you want CF 2.0, install the QFE that adds it to the catalog.


--
Chris Tacke - Embedded MVP
OpenNETCF Consulting
Managed Code in the Embedded World
www.opennetcf.com
--


"Catalin Lungu" <lungucatalincostel@yahoo.es> wrote in message
news:ua8PZ0KYHHA.1244@TK2MSFTNGP04.phx.gbl...
> Hi guys,
> Platform Builder 5.0 gets only netcf 1.0? I tried to build an image with
> the wizard and the only netcf that I can select is 1.0
> It's posible to use netcf 2.0?
>
> Thanks,
> Catalin
>

I updated all patches until 2007 and now I can use it.
Thanks again.

"<ctacke/>" <ctacke[@]opennetcf[dot]com> escribió en el mensaje
news:u9ofQrLYHHA.208@TK2MSFTNGP05.phx.gbl...
> PB 5.0 came out before CF 2.0, so yes, by default it only has CF 1.0. If
> you want CF 2.0, install the QFE that adds it to the catalog.
>
>
> --
> Chris Tacke - Embedded MVP
> OpenNETCF Consulting
> Managed Code in the Embedded World
> www.opennetcf.com
> --
>
>
> "Catalin Lungu" <lungucatalincostel@yahoo.es> wrote in message
> news:ua8PZ0KYHHA.1244@TK2MSFTNGP04.phx.gbl...
>> Hi guys,
>> Platform Builder 5.0 gets only netcf 1.0? I tried to build an image with
>> the wizard and the only netcf that I can select is 1.0
>> It's posible to use netcf 2.0?
>>
>> Thanks,
>> Catalin
>>
>
>