IPv6

IPv6 gets installed by dafault when using SP2. Which component do I
have to remove from my TD configuration so that IPv6 is removed but
IPv4 is retained in the image? Will removing IPv6 have adverse
consequences on any dependent components used by IPv4? In short, I need
only IPv4 in my image.

Thanks

what I have done is put the following command in the phase 3498
snetcfg -u ms_tcpip6

I have never notice problem with IPV4.
I don't like manual operations, if I wanted to remove ipv6 in
TD, I must do a manual operation. and since adding ipv6 does
not increase too much image size, so I prefer uninstall it at
run time.

HTH

Zirong

"Manoj" <manoj.mehta@med.ge.com> wrote in message
news:1144443274.226075.12780@t31g2000cwb.googlegroups.com...
> IPv6 gets installed by dafault when using SP2. Which component do I
> have to remove from my TD configuration so that IPv6 is removed but
> IPv4 is retained in the image? Will removing IPv6 have adverse
> consequences on any dependent components used by IPv4? In short, I need
> only IPv4 in my image.
>
> Thanks
>

Thanks for the information...