problem with rs232 interfacing

i am interfacing a fpga board to a pc using rs232 standard.
the fpga is spartan 2 of xilinx make. the on board oscillator is of
frequency 8MHz. i want to transmit the data appearing on the fpga
output pins to a pc, i.e., write this data onto a file in the pc. baud
rate is 9600. 1 start bit and 1 stop bit. no parity.
i have written the code in c using bioscom.
but the after opening the output file, i find it empty.
plz help
regards arun

This isn't a CF question, and you've not provided near enough information to
help you.

-Chris

"heartbreakkid" <arunkarthik.com@gmail.com> wrote in message
news:1141789550.614978.196260@j33g2000cwa.googlegroups.com...
>i am interfacing a fpga board to a pc using rs232 standard.
> the fpga is spartan 2 of xilinx make. the on board oscillator is of
> frequency 8MHz. i want to transmit the data appearing on the fpga
> output pins to a pc, i.e., write this data onto a file in the pc. baud
> rate is 9600. 1 start bit and 1 stop bit. no parity.
> i have written the code in c using bioscom.
> but the after opening the output file, i find it empty.
> plz help
> regards arun
>