After sp4 install on W2k Pro, system won't stop rebooting.

The best way is to perform a dual install. To do this,
boot from the W2K CD and install a fresh copy in A NEW
DIRECTORY. Do no install in the default winnt because you
will overright what is there. After the fresh install,
make the necessary changes to the corrupted installation
or copy your data to the new installation. You can then
either boot from the original installation and remove the
new or keep the new and remove the original.

Keith

>-----Original Message-----
>This SP4 is a piece of garbage. I'm hosed...didn't make a
>backup from SP3 to SP4. Is there anyway I can remove the
>SP4 and put back the SP3 in ?
>
>John
>
>>-----Original Message-----
>>Last night I updated to SP4 on my Windows 2000 Pro
>system.
>>Apon rebooting, just before making it to the logon box,
>my
>>system rebooted itself again. During the next start up I
>>actually got to see the logon box, but again my system
>>rebooted (before I was able to even start to type in my
>>password). So that is the current state of my computer.
>It
>>won't stop rebooting. And didn't I don't even get to log
>>on I can't go look for the problem. When I try to enter
>>any of the 3 safe modes I get the following very
>unhelpful
>>stop error.
>>
>>*** STOP: 0x0000001E
>>(0xC0000005,0x00000000,0x00000000,0x00000000)
>>KMODE_EXCEPTION_NOT_HANDLED
>>
>>I've looked up the error but still don't actually have a
>>solid place to start looking for the problem. Anyone
have
>>a suggestion of where to start looking for this one?
>>
>>Best Regards,
>>-Tony Kirk
>>.
>>
>.
>