Problem with riprep

Hi
Whenever i try to run riprep i get the following error
The procedure entry point Enableprivilege could not be located in the
dynamic link libary setupapi.dll
any ideas anyone?


--
reply to group@dtsscotland.ihateprocesseddodgysmellingmeat.com

remove the obvious spamtrap :-)

I've read that is a problem in WXP and you have to
update riprep. Just search the news. Regards.

>-----Original Message-----
>Hi
>Whenever i try to run riprep i get the following error
>The procedure entry point Enableprivilege could not be
located in the
>dynamic link libary setupapi.dll
>any ideas anyone?
>
>
>--
>reply to
group@dtsscotland.ihateprocesseddodgysmellingmeat.com
>
>remove the obvious spamtrap :-)
>
>
>.
>

Hi
found the update earlier today
now i get the error server doesn't have a suitable image
or similar
ah well, back to the drawing board
server has an image built from the same install disk as the pc:-(

"Santi" <smc@marvalsa.com> wrote in message
news:054101c3422d$eb294da0$a001280a@phx.gbl...
> I've read that is a problem in WXP and you have to
> update riprep. Just search the news. Regards.
>
> >-----Original Message-----
> >Hi
> >Whenever i try to run riprep i get the following error
> >The procedure entry point Enableprivilege could not be
> located in the
> >dynamic link libary setupapi.dll
> >any ideas anyone?
> >
> >
> >--
> >reply to
> group@dtsscotland.ihateprocesseddodgysmellingmeat.com
> >
> >remove the obvious spamtrap :-)
> >
> >
> >.
> >