How to setup a wireless access point?

Mark

Guest

Posts: n/a

10th May 2005

Basically, at the moment we have two networks.
One in the building which has three computers on that can see each
other fine, then we have a drive test vehicle which has two laptops in
which can see each other. We have a wireless access point, which can
see the two laptops in the vehicle and obviously the other two in the
building. When in the vehicle on either of the laptops it can see the
computer connected to the wireless acces point but not the two
computers in the building.

Why is this?

All are on the same workgroup?

« Bandwidth Monitoring Program Needeed..?! | Check windows sid »

Thread Tools
Show Printable Version Email this Page
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Re: Wireless association failed beacause Windows did not receive any response from the wireless router or access point	Jack \(MVP-Networking\).	Windows Vista Networking	0	14th Oct 2008 10:51 PM
Re: Wireless association failed beacause Windows did not receive any response from the wireless router or access point	Robert L. \(MS-MVP\)	Windows Vista Networking	0	14th Oct 2008 02:58 PM
How to setup Netgear Wireless Access Point?	sdeyoreo@hotmail.com	DIY PC	1	6th Aug 2005 08:48 PM
Wireless access point vs. cable/DSL wireless router.	alex	Windows Networking	3	4th Jul 2005 07:51 PM
Centrino wireless won't work with old Linksys wireless access point	steveK	Windows Networking	1	5th May 2005 07:35 AM