has anyone else encountered the problems, having installed Service pack 4. The client could not connect to the terminal server. The server may be too busy

This pops up, but if i re-type the server name (either name or IP address), changing case, the connection will then establish

Much confusion. I would like to check the server as i have access, but i now cannot make any connection at all ????

Graeme Brodi

Managing Directo
ABZ Airborne Limited

I assume you rebooted the server after installing the
Service Pack? When I installed it on Terminal Servers, I
was just going to finish the install during the day, and
then reboot them that night, but no, they wanted to be
rebooted immediately, or they were not going to let anyone
on. I had to reboot one of them twice, before it would
accept anything but a console logon.
>-----Original Message-----
>
>has anyone else encountered the problems, having
installed Service pack 4. The client could not connect to
the terminal server. The server may be too busy.
>
>This pops up, but if i re-type the server name (either
name or IP address), changing case, the connection will
then establish.
>
>Much confusion. I would like to check the server as i
have access, but i now cannot make any connection at
all ?????
>
>Graeme Brodie
>
>Managing Director
>ABZ Airborne Limited
>.
>