Mine run for approx 30 minutes then I got to the sorting of found channels
(Swedish Telia cable TV network)
The tuner scans all channels that the tuner can handle and takes a while...

Oh and you need a good TV signal quality...

/J

"Deccard" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
> Hi all,
>
> Hope someone here can help me with my problem of scanning my cable TV
> supplier for available TV channels with my ATI All-in-Wonder 9000 Pro
> card.
>
> I got the card installed ok and everything works perfectly, except the
> scanning of TV signals (channels), when I connect the TV cable to the
> cable/antenna input plug.
>
> My manual says:
> "Note: to watch TV on your PC, you will first have to configure
> the TV channels. A channel detection utility will be launched
> automatically the first time you launch the TV module.
> Follow the on-screen instructions..."
>
> Yeah, right...
> but there are no instructions popping up, at all.
> The TV module loads, and stays on my display with the initial logo, as
> if it
> attempts to start the scanning thing, but nothing happens ...
> And it stays like that for 20 mins (of forever?)...
> So, I gave up.
> It obviously doesn't load the scanning device at all or load it
> incorrectly?
>
> Anybody here with the same experience, and with a way to get on?
>
>
> Any help will be most appreciated, or I shall have to assume the TV
> tuner
> is simply dead???
>
>
> Regards,
> Deccard

I made it! - I knocking made it!
Work, that is.

For those of you who should dispair, try my solution - simple as it is...

Go get the listed Windows XP updates at:
http://mirror.ati.com/support/driver...wonder-xp.html

Do exactly what's said there, 1 by 1...
And you might succeed too ;-)

Bravo, ATI - so you didn't let me down in the end - but I must say,
it wasn't easy finding the solution, hrmpf!


Regards & Enjoy,
Deccard