I promise
Using RAM EWF Registry component I can now run ewfmgr c: and it sees the volume on the CF card. However, I can't enable protection. When I run ewfmgr c: -enable it displays

*** Enabling overla

Protected Volume Configuratio
Type RA
State DISABLE
Volume ID AC CD AC CD 00 7E 00 00 00 00 00 00 00 00 00 0
Device Name "\Device\Harddisk0\DP(1)0-0+1
Max Levels
Clump Size 51
Current Level

Memory used for data 0 byte
Memory used for mapping 0 byte

And I see the same report if I type ewfmgr c: again after trying to enable it, i.e. it is still disabled. Any ideas?

You must gracefully reboot your device.

Regards,
Slobodan

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Have an opinion on the effectiveness of Microsoft Embedded newsgroups? Tell
Microsoft!
https://www.windowsembeddedeval.com/...ity/newsgroups
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

"Colin Parker" <(E-Mail Removed)> wrote in message
news:AA325C73-F059-4AD5-AC1A-(E-Mail Removed)...
> I promise!
> Using RAM EWF Registry component I can now run ewfmgr c: and it sees the
volume on the CF card. However, I can't enable protection. When I run ewfmgr
c: -enable it displays:
>
> *** Enabling overlay
>
> Protected Volume Configuration
> Type RAM
> State DISABLED
> Volume ID AC CD AC CD 00 7E 00 00 00 00 00 00 00 00 00 00
> Device Name "\Device\Harddisk0\DP(1)0-0+1"
> Max Levels 1
> Clump Size 512
> Current Level 1
>
> Memory used for data 0 bytes
> Memory used for mapping 0 bytes
>
>
> And I see the same report if I type ewfmgr c: again after trying to enable
it, i.e. it is still disabled. Any ideas?