Hi All!

I have posted this problem before and not received a response - but the
problem continues despite my best efforts... and thus I go fishing again..

I have a P3 Epox motherboard and recently installed a Seagate Barracuda 80
GB hard drive (7200.7 - ST380011A). My motherboard doesn't recognise the
drive at 80GB so I had to change the jumpers to limit the drive to 32GB (as
Primary Slave).

I then partitioned the drive into a FAT32 partition for data files and an
EXT3 partition for RedHat Linux. I have WinXP Pro on another drive -
Primary Master.

My problem is that the drive isn't 'remounted' on boot - I have to go to the
hardware wizard to get XP to re-detect the drive.

How might I correct this?

Thanks for any advice!

Rob

Robert, try moving the drive as Master on the Secondary IDE channel.
"Robert Mark Bram" <(E-Mail Removed)> wrote in message
news:%(E-Mail Removed)...
> Hi All!
>
> I have posted this problem before and not received a response - but the
> problem continues despite my best efforts... and thus I go fishing again..
>
> I have a P3 Epox motherboard and recently installed a Seagate Barracuda 80
> GB hard drive (7200.7 - ST380011A). My motherboard doesn't recognise the
> drive at 80GB so I had to change the jumpers to limit the drive to 32GB
(as
> Primary Slave).
>
> I then partitioned the drive into a FAT32 partition for data files and an
> EXT3 partition for RedHat Linux. I have WinXP Pro on another drive -
> Primary Master.
>
> My problem is that the drive isn't 'remounted' on boot - I have to go to
the
> hardware wizard to get XP to re-detect the drive.
>
> How might I correct this?
>
> Thanks for any advice!
>
> Rob
>
>
>
>