[netrate]

How do I hook up the LED and sensors on an ATRIX tower?
I purchased a full size ATRIX tower
http://btecanada.com/catalog/product...oducts_id/5260

The computer runs fine, but the instructions for how to hook up the front side LED's and the sensors is lacking. How the heck do I do this? Is there a walk-thru for this stuff? Thanks

[TriplexDread]

Hiya mate each of the connections in the tower should be marked

PWR LED = Power Light
HDD LED = Hard drive light

etc.

IN your manual for the Motherboard it will have a diagram of all the pin and the + and - for those pins to help you connect the jumpers onto the board.

If you have extra LEDS and whatnot they usually connect to a normal Power connector on the PSU

Let us know how you get on

[netrate]

Thanks. It was a Molex cable. Now I need to figure out how to do the sensors. The instructions on the Case are not clear at all...There are two 4 pin fan1 and fan2 cable that is supposed to give me fan speeds, but I am not sure where to hook these up - do they go to the Fan Chasis?