I am trying to store my calling card information in
Dialup. I created a new location and called it "Calling
Card". I then clicked the Calling Card tab and created a
new calling card. Under the heading "Calling card
dialing steps:" I set out the steps, ie. dial access
number, wait 4 seconds, dial account number, wait 4
seconds, dial phone number.

I set out the rules and when I go to connect it dials all
of the numbers together without waiting for the defined 4
seconds. Why won't it follow the rules?

in addition, in the "Calling card dialing steps" it will
follow the "Access Number", "Account Number", "PIN"
and "Destination Number", I can even use "Specify Digits"
for * or #. I just can't get it to put in a delay
using "Wait for Prompt..." or "Specify Digits" and using
commas. When I put in a delay or a comma it disapears
when I close the "Edit Calling Card" window. The "Phone
and Modem Options" widow says the Phone number will be
dialed as... and shows all the numbers with no commas.