Hi All,

I have one issue , i had build the Xp Embedded image and i had tried
that on D drive and it works successfully on the dual boot system.

Now i want to deploy the image on the raw/ target machine. by SDI
approach

The steps that i followed are :

1. I had changed the setting in same image using target designer to C
drive and build the
another image.
2. With help of the SDI loader i created the virtual drive for target
disk.
3. Then boot the target machine by Windows Xp Embedded CD 1 (before
this i had used the
bootprep)
4. Created one partion in Flash disk of target machine using DiskPart
5. Formatted this partition by Format c: /FS:FAT32
6. Copy the SDI file to machine by using the "sdimgr" command

But the problem i am facing is that after copying the SDI file i
reboot the system and FBA start and after some times it restart and
again FBA start . And this goes to infinite loop.. nothing happens
after only FBA runs and then again system restarts.

I think i have to add some component in Image.

Can any body help me out in this.

Thanks,
Lalit Gautam
System Architect
+91-9819101570

Him not a expert myself but with what I read, I'm pretty sure that you
need to run the FBA before creating your SDI file.